Flange Adaptor Information

HDPE Pipe Grade Material: PE 3408
Material Cell Class #345444C
"T" must be at least - 1.25 times pipe wall thickness for full pressure rating.
One bolt length is used for each pipe diameter for all DR's. "T" is constant using DR 11 (or lowest available DR by size)
The face diameter fits inside bolt-circle to promote alignment and concentricity, with sealing.
"H" must be long enough to allow butt-fusion in all applicable fusion machines, size on size or larger. Consult fusion machine manufacturers for their required minimum length.
"R" must be matched to the radius of the metal back-up ring.
Corrosion protected convoluted Ductile-Iron back-up rings are recommended.
OD dimensions and tolerances machined in compliance with specifications of ASTM F714.
Flange adaptor wall thickness is 10% thicker than pipe to accommodate pipe end toe-in and out-of-roundness, while assuring virtually 100% butt-fusion contact.
Flange adaptors may be fused to same DR and to one standard DR higher (i.e., DR17 to DR21)

Copyright ® 2003 - 2008 \| Oxford Plastics Inc. \| All Rights Reserved
Oxford Plastics Inc. ~ PO Box 119, Oxford Road 6, Embro, Ontario, CANADA, N0J 1J0
Office: 519.423.6232 ~ Fax: 519.423.6057 ~ Toll Free: 1.800.263.0502